Studs
 Full
Thread Studs
Full thread studs are made by cutting all thread rod
to length or roll-threading pitch diameter cut blanks.
One important consideration in ordering full thread
studs is specifying the length. There are two standards.
One is measuring the overall length of the part. The
other is measuring from the first full-form useable
thread on one end to the first full thread on the other.
As studs are generally chamfered on both ends the first-to-first
measurement will be 1 to 2 pitches less than the overall.
First-to-first measurements are usually specified in
high temperature and high pressure applications, particularly
where ASTM A193 is specified.
Nickel
Systems stocks all thread rod in Alloy C276 (Hastelloy
C®), Alloy 20, 316 Stainless, and 18-8 Stainless
which can be cut to length and shipped in short order.
We can also supply studs to A193 specs (B7, B8, B8C,
B8M, B8R, B8S, B8T), Monel® (Alloy 400), AL6XN®,
Duplex Stainless (Alloy 2205), Nitronic® (50 and
60), and other non ferrous materials.
|
